[SUCCESS] HS + MSI RX570 ARMOR OC + ASUS P7P55D (legacy BIOS)

[keniceland]

I would like to share my positive experience with High Sierra 10.13.6 with following HW:

MB: ASUS P7P55D (legacy BIOS)
GPU: MSI RX570 ARMOR OC 8G (before was a Sapphire Radeon HD5750)
Screen: 4K Samsung C34H890
HDMI KVM: TESmart 4K

I was running on 10.13.3 with Sapphire Radeon HD5750, and I made the new GPU working with following clover settings:
- InjectATI
- RadeonDeInit
- FrameBuffer: Acre (all others Orinoco, Dayman, Guariba, Hullaga --> black screen)
- ATI Device ID: 0x67DF1002
- Lilu & WhateverGreen kexts (under EFI/CLOVER/kexts), but I can boot without


Then the update to 10.13.6 went fine too.
I'm observing just one strange issue:

quite frequently during the normal usage the screen become black and I need to switch off/switch on the HDMI KVM.​

I suspect this is related to the KVM switch... The same is working properly if hackintosh is running MsWin10 or Ubuntu or if Im directly connected to the screen.

Update:
Installed Mojave 10.14.2 with the same settings no issues.
Im confirming the bugged KVM...

 

[Salinger]

Thanks for sharing...It helps me a lot!!!

 

[amuse.me]

I would like to share my positive experience with High Sierra 10.13.6 with following HW:

MB: ASUS P7P55D (legacy BIOS)
GPU: MSI RX570 ARMOR OC 8G (before was a Sapphire Radeon HD5750)
Screen: 4K Samsung C34H890
HDMI KVM: TESmart 4K

I was running on 10.13.3 with Sapphire Radeon HD5750, and I made the new GPU working with following clover settings:
- InjectATI
- RadeonDeInit
- FrameBuffer: Acre (all others Orinoco, Dayman, Guariba, Hullaga --> black screen)
- ATI Device ID: 0x67DF1002
- Lilu & WhateverGreen kexts (under EFI/CLOVER/kexts), but I can boot without


Then the update to 10.13.6 went fine too.
I'm observing just one strange issue:

quite frequently during the normal usage the screen become black and I need to switch off/switch on the HDMI KVM.​

I suspect this is related to the KVM switch... The same is working properly if hackintosh is running MsWin10 or Ubuntu or if Im directly connected to the screen.

Update:
Installed Mojave 10.14.2 with the same settings no issues.
Im confirming the bugged KVM...

hi keniceland i have a question, did you install using unibeast?

where did you sett this clover settings?? (is it post or pre install setting?):
- InjectATI
- RadeonDeInit
- FrameBuffer: Acre (all others Orinoco, Dayman, Guariba, Hullaga --> black screen)
- ATI Device ID: 0x67DF1002
- Lilu & WhateverGreen kexts (under EFI/CLOVER/kexts), but I can boot without

im sorry for the noob question im just a newbie in this area