HP Z800 Bootloader Options screen choose UEFI Boot Mode or Legacy Boot Mode

[xylomat]

Dear guys,

I´d like to set up on my HP Z800 the Sierra from the scratch - like shown at https://www.tonymacx86.com/threads/...ierra-on-any-supported-intel-based-pc.200564/

So i asked a friend of mine to give a favour and do step one and two on his mac.

... there are two options (step 2 / point 13) for UEFI or Legacy. => I´d like to verify to choose Legacy Boot Mode, cause the board of the Z800 doesn´t not support UEFI mode. Is this correct?

thanks a lot for your reply!
best regards

 

[Ackros]

legacy, even if it was uefi supported you can always use legacy