How to enable QE/CI?

[thelostswede]

I can't seem to figure out how to enable QE/CI.
I've got a GeForce GTS 250 card which should be working, but for some reason it's not detected properly. I just get a generic Nvidia card, although I can run the full resolution of my display. I've tried a few different Nvidia kexts, but alas to no luck.
Anyone else using this card that got it working properly?

 

[thelostswede]

Never mind, NVEnabler is working, just not listing my graphics card name and detail properly

 

[techsnot]

Never mind, NVEnabler is working, just not listing my graphics card name and detail properly

may i ask what you did to fix it?
i got a gtx 260, that's working with nvenabler. but no QE/CI

 

[tonymacx86]

Never mind, NVEnabler is working, just not listing my graphics card name and detail properly

may i ask what you did to fix it?
i got a gtx 260, that's working with nvenabler. but no QE/CI

I'd try using GraphicsEnabler in com.apple.boot.plist and if you're on RC4, use

PCIRootUID=0

or

PCIRootUID=1

at login. It may work. Also, put your specs in your sig. If it does work, you may not need nVenabler at all!

 

[techsnot]

Never mind, NVEnabler is working, just not listing my graphics card name and detail properly

may i ask what you did to fix it?
i got a gtx 260, that's working with nvenabler. but no QE/CI

I'd try using GraphicsEnabler in com.apple.boot.plist and if you're on RC4, use

PCIRootUID=0

or

PCIRootUID=1

at login. It may work. Also, put your specs in your sig. If it does work, you may not need nVenabler at all!

Hi there. I got my gtx 260 up and running with 3d accel now by following this guide: http://www.infinitemac.com/f19/guide-ge ... ard-t4057/


system profiler does not ay anything about it, but i can now start world of warcraft without getting a message about not beeing able to start 3d acceleration, so iam guessing its working. glxinfo also say direct rendering: yes, which it didnt before