- Joined
- Dec 14, 2013
- Messages
- 25
- Motherboard
- GA-Z87X-UD4H
- CPU
- i7-4770K
- Graphics
- RX 580
- Mac
- Classic Mac
- Mobile Phone
I've done a massive amount of digging around this but I'm at a loss so seeking help.
I have a Benq BL3200 monitor which has a Genesys Logic, Inc. USB 3.0 card reader on it. I have mapped all my USB port very successfully and my build is working perfectly apart from one issue. When I first boot my hack that Genesys card reader is running USB 2.0, if I unplug the USB cable to the monitor and plug it back in again in comes up as USB 3.0 and works at full speed.
How can I get that device to come up on USB 3.0 at startup?
I have a Benq BL3200 monitor which has a Genesys Logic, Inc. USB 3.0 card reader on it. I have mapped all my USB port very successfully and my build is working perfectly apart from one issue. When I first boot my hack that Genesys card reader is running USB 2.0, if I unplug the USB cable to the monitor and plug it back in again in comes up as USB 3.0 and works at full speed.
How can I get that device to come up on USB 3.0 at startup?