- Joined
- Feb 13, 2010
- Messages
- 64
- Mac
- Classic Mac
- Mobile Phone
Hi,
just short question:
I've read somewhere on the web (but in a pretty old thread) that with the 4850 (and other ATI 4XXX) dual monitor is not possible when you have 1 monitor connected via VGA (or DVI->VGA) and 1 monitor via DVI.
Source: http://www.insanelymac.com/forum/index.php?showtopic=177112
I tried it myself using LegacyATI4800controller.kext and the result was that whenever I had a monitor connected via DVI the VGA-monitor got no signal.
By the way: The VGA monitor only gets signal on DVI-Port2 (more far away from the mainboard).
I don't have 2 DVI-monitors, so I can't test that but I think that should work.
So, is my information correct that I can't use a VGA and a DVI monitor or are there any newer/better drivers?
Thanks!
just short question:
I've read somewhere on the web (but in a pretty old thread) that with the 4850 (and other ATI 4XXX) dual monitor is not possible when you have 1 monitor connected via VGA (or DVI->VGA) and 1 monitor via DVI.
Source: http://www.insanelymac.com/forum/index.php?showtopic=177112
I tried it myself using LegacyATI4800controller.kext and the result was that whenever I had a monitor connected via DVI the VGA-monitor got no signal.
By the way: The VGA monitor only gets signal on DVI-Port2 (more far away from the mainboard).
I don't have 2 DVI-monitors, so I can't test that but I think that should work.
So, is my information correct that I can't use a VGA and a DVI monitor or are there any newer/better drivers?
Thanks!