Clover boot menu no longer working.

[arkhangel]

Hello,

So Clover menu was working fine up until today.
I boot PC and I boot straight into windows instead of the Clover menu showing up.
I can see that the Clover UEFI is still there, I can even mount it from Windows from powershell using:

mountvol g: /s

and browse the partition.

Anyway trying to understand what could have gone wrong for it not to show up in the MOBO boot menu anymore...

 

[arkhangel]

Just some troubleshooting on this:

I can boot back into Clover using the EFI USB Installer.
Once I go into OSX and start Multibeast I re-install the Bootloader for EFI, I see the EFI Mounted in finder - all good signs.
But when I restarted to test, no Clover menu.

I used the EFI USB again to go back into OSX and the EFI was no longer mounted in finder...

Any ideas?

Thanks!

 

[Going Bald]

OS X and Windows same drive or separate? If separate check UEFI for CMOS reset changing HDD boot order.

 

[arkhangel]

OS X and Qindows same drive or separate? If separate check UEFI for CMOS reset changing HDD boot order.

Same drive.

 

[Going Bald]

Installed Windows and OS X both UEFI mode or was the Windows partition formatted MSDOS FAT with disk utility?

 

[arkhangel]

I fixed this by just deleting the EFI partition drive and reinstalling it from Multibeast.