- Joined
- Oct 20, 2012
- Messages
- 30
- Motherboard
- 10.10 (14A389)
- CPU
- i5 4670k
- Graphics
- GTX 750 Ti
- Mac
- Classic Mac
- Mobile Phone
Hi guys,
I had the -awesome- idea of updating my Hackintosh from 10.9.2 to 10.9.3 today with the Combo Update. Everything was working fine before and I had absolutely no errors at all.
However, since I updated, I can't boot anymore. The system hangs up even if I try Safe Mode. After the first restart, I had kind of a kernel panic caused by FakeSMC (at least, from what I've seen) and now every time I try to boot it's stuck at the same point (see screenshots). I can boot in single user mode and get the console though.
I used MultiBeast 6.2.0 when I installed 10.9.2 to apply the FakeSMC patch and HDAEnabler (my motherboard uses the ALC892 audio driver). Everything was fine then.
Do you have any idea about what may cause this? Is it because of FakeSMC or HDAEnabler? Should I delete one (or both) of those in Single User mode?
Specs:
MB: GA-Z87M-D3H
GC: Intel HD4600 (DVI port used)
1x 256GB SSD
Thanks guys!
Info: 1st screen is booting in safe mode. 2nd is booting in verbose mode.
Edit: It seems like the MacPro6,1 definition I was using caused this mess. Is it really compatible with this new update? Are you guys using it?
I had the -awesome- idea of updating my Hackintosh from 10.9.2 to 10.9.3 today with the Combo Update. Everything was working fine before and I had absolutely no errors at all.
However, since I updated, I can't boot anymore. The system hangs up even if I try Safe Mode. After the first restart, I had kind of a kernel panic caused by FakeSMC (at least, from what I've seen) and now every time I try to boot it's stuck at the same point (see screenshots). I can boot in single user mode and get the console though.
I used MultiBeast 6.2.0 when I installed 10.9.2 to apply the FakeSMC patch and HDAEnabler (my motherboard uses the ALC892 audio driver). Everything was fine then.
Do you have any idea about what may cause this? Is it because of FakeSMC or HDAEnabler? Should I delete one (or both) of those in Single User mode?
Specs:
MB: GA-Z87M-D3H
GC: Intel HD4600 (DVI port used)
1x 256GB SSD
Thanks guys!
Info: 1st screen is booting in safe mode. 2nd is booting in verbose mode.
Edit: It seems like the MacPro6,1 definition I was using caused this mess. Is it really compatible with this new update? Are you guys using it?
