2007 Mac Pro Mod HELP

[Ramex]

I'm almost complete with my version of a mac pro mod, all I have left to do is get the front panel power button and led working, I'm using a msi A88XM micro atx board and I can't figure out how to pin it out properly. below is what I have to work with.

 

[neilhart]

I'm almost complete with my version of a mac pro mod, all I have left to do is get the front panel power button and led working, I'm using a msi A88XM micro atx board and I can't figure out how to pin it out properly. below is what I have to work with.

Ramex you are in luck as this is well documented.

It is explained in post # 17 of mooner’s thread here: http://www.tonymacx86.com/mac-pro-m...ro-gigabyte-z68mx-ud2h-b3-mac-pro-case-2.html

And in my thread check post # 15 at http://www.tonymacx86.com/mac-pro-mods/28892-neilharts-mac-pro-hack-2.html

And/or you can go directly to the Mac Pro Power Switch and you will find a green circuit board with three wires attached. The center wire on this circuit card is the common/return pin for both the switch and the LED and it needs to be wired to a return pin on your system (use the front panel header (-) pin). This leaves the two outside pins on the circuit card; wire one to the (+) pin 2 and one (+) 6 on the front panel header.

Good modding,
neil