Hi,
I have an issue that my build wakes up shortly after I put it to sleep. First, the system goes into sleep after asking it to, the screen goes dark, and shortly after, the fans stop spinning, and the RGB LEDs on different components shut down (except my RAM RGB:s, which stay turned on). But...
After updating to 11.2 I suddenly couldn't get the hack to sleep—a familiar problem from many updates. The screen would go black and after a couple of seconds come back on. In Activity Monitor the only thing shown to prevent sleep was WindowUser and that is a vital core component, therefore no...
When I put my machine to sleep, the display turns off, but then it restarts back to the Clover boot screen a few seconds later. Following the restart, I get these results in the syslog when I run:
log show --style syslog | fgrep "sleep"
2018-06-15 11:06:06.159494-0600 localhost kernel[0]...
I upgraded my hackintosh to 10.9.3 (Chimera 3.0 and MB 6.3), I noticed that it is running very hot since then. Sleep mode does not work either, after few minutes of idle instead of sleeping it goes into boot cycle, fails to boot completely and gets very hot, closing the display does the same...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.