Search results

So I need to: 1. Disable InjectIntel 2. Set FakeID to 0x00000000 3. Leave ig-platform-id as 191B0000 In order to boot? These settings still stick me on the OsxAptioFixDrv screen.

Here is my /L/E folder... And my config.plist is attached to the post. I have Inject-Intel set to yes, and fakeID set to 19120000. This config.plist worked with the FakePCIID_Intel_SKL_Graphics.kext. Do I need to modify them to get FakePCIID_Intel_HD_Graphics.kext working?

Booting works just fine, however About This Mac is reporting an Intel HD530 with 7MB of memory, and there are artifacts everywhere (which I assume means I'm not getting acceleration). Switching from FakePCIID_Intel_SKL_Graphics.kext to FakePCIID_Intel_HD_Graphics.kext caused my boot to halt on...

Ok, that would be why I'm hanging on the old error then. So I should take all of my kexts that I used on the USB Clover and copy them to /S/L/E or /L/E? Also, I found an old thread that you posted in about FakePCIID_Intel_HD_Graphics.kext being good to go for Skylake graphics. So I don't want...

There aren't any extra kexts installed to /S/L/E, and FakeSMC.kext + RealtekRTL8111.kext are installed to /L/E.

I found a thread regarding those... do they go in /EFI/CLOVER/kexts/10.11 or /EFI/CLOVER/kexts/Other if I'm still trying to boot off of my USB with them? Edit: So I managed to get my install booting with a combo of the fakePCIID kexts and changing my Intel FakeID in clover. So I attempted to...

I apologize for the double post, but I tried booting again and noticed that before the verbose output ends but before the blinking cursor appears, a bunch of lines flash across all at once. They pertain to [IGPU], so could that mean that there is an issue with my graphics? I have not done...

I'm not sure if I can upload multiple images in addition to the Clover.zip, so I've inlined them because the imgur album put them in the wrong order. Here are two images from the verbose boot, before the flashing cursor appears: Now, on my blinking-cursor screen, sometimes when it flashes...

Ok, quick update: I solved my previous problem by using Disk Utility in the installer instead of Macdrive on Windows to create my install partition. I ran Disk Utility>Selected my 1TB drive>Erase>named it and made sure it said GUID Partition Table>Apply. I actually ran this twice in the same...

Does anyone know what could have gone wrong with my build? I attached the EFI folder that correctly detects my SATA drives (Thanks RehabMan for the config fix!). My problem is that I will boot into the installer, and get my install partition all set up (at least 500gb HFS+ Journaled), but when...

Thank you!! That was exactly what I needed! But now I've run into another problem... I created my HFS+ partition in Macdrive to be 512GB on my 1TB hard drive, leaving the remaining half of the drive unallocated. Upon booting to the installer, I used Disk Utility and enabled Journaling on the...

Ok, so I followed the guide to the best of my knowledge of hackintoshes. I am trying to install 10.11.5, and I can get the installer to boot just fine. The only problem is, Disk Utility/System Information/Terminal 'diskutil list' will not read any of my SATA internal drives (I have a 1TB HDD and...