(Thanks to @Zip1 for helping put this together!)
Press F2 to toggle to Advanced Mode.
Press F7 to Load Optimized Defaults.
Now make the following settings:
Tweaker
Advanced CPU Settings → VT-d → Disabled
Extreme Memory Profile (X.M.P.) → Profile 1
Settings
Internal Graphics → Enabled
Above 4G...
In addition to the different drivers, mojave is Samsung 970 pro, catalina is wd sn750, all other configurations are the same, including EFi files, can’t believe it
In addition to the different drivers, mojave is Samsung 970 pro, catalina is wd sn750, all other configurations are the same, including EFi files, can’t believe it
In addition to the different drivers, mojave is Samsung 970 pro, catalina is wd sn750, all other configurations are the same, including EFi files, can’t believe it
It's useless, it has been tested. I gave up. I had to erase my windows on my other SSD (Western Digital sn750), follow your method, make a USB drive, and installed the latest 10.15. 5 smoothly. Therefore, I can see two Apple systems on the clover startup interface, and then I used the data...
Last night, the system failed to start after I cleared CMOS. I then started the system with a backup and replaced it with OsxAptioFix2Drv-free2000.efi, and the system started normally. I'll unlock CFG your way right away. Replace it again with the OcQuirks.efi three-piece set. OK, my Mojave's...
Unfortunately, I still failed. There is no problem to boot the current system with USB disk . However, this is still the case when I click Update. I am considering whether to switch to the original EFI to test the upgrade.
I came again, as shown in the picture, I should have completed this command. It is possible to boot to Mojave through the disk. Now I am ready to test to boot with U disk, upgrade the installer
The 10.14.6 (mojave) system I am running has removed the kext you listed. And run Kext Utility to rebuild the kernel cache.
But in the beginning, because it could not start, I restored these kexts from the backup and then deleted them. . . After a few loops, I am not sure to run Kext Utility...
Hello CaseySJ. I follow your method, the USB drive can not start. I only replaced the three files OcQuirks, OcQuirks.plist and FwRuntimeServices with the original OsxAptioFix2Drv-free2000.efi to start successfully. But my current system 10.14.6 is able to use your May 2020 Update-Catalina...
Please take a look. I have both drawings marked.
I made some changes to the installation procedure. I didn't use your EFIClone-v2.sh. I used GUI to erase the disk in the first step. After that, I cloned the APFs partition by ccc, then mounted the EFI partition of the two disks directly. I...
@CaseySJ, I came to China and thanked the moderators for sharing their experience. Now the system has been built. Namely
I9-9900K,Z390 Design ARE,Radeon RX 5908GB
But, when I configure it, I use the SSD WD SN750 500G, which feels like occasional carton when I use it for a few days. So, I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.