Search results

Hello, I followed the installation guide, and installed UniBeast on a flash drive. I had to install it in Legacy boot, because when I did it with UEFI, the flash drive didn't show up in my BIOS. What can I do? Clicking Continue does nothing. Thanks, skiilaa

Last night I left macOS running on idle for about 4 hours and then I tried to wake it from sleep to shut it down properly. I couldn’t, so I just pulled the plug. I didn’t power it on that day again. Next day, I tried to turn on the PC, and I was stuck in a bootloop. No BIOS graphics, no POST...

After installing Clover to the macOS disk, HS doesn't boot. Only from the USB. The boot always hangs after the progress bar has appeared. In verbose mode, it always hangs different times. I've attached my config below. I don't use UEFI, my mobo doesn't support it. I'm not emulating NVRAM.

Every time Intel Power Gadget starts, my PC just reboots. Is a DSDT required to run it? If so, how to get a DSDT?

I'm trying to create a High Sierra flash drive with UniBeast but it always fails at the error "Couldn't modify plist" after copying apfs.efi. 01/01/18 19:03:56 - Starting UniBeast 8.1.0-20171111 01/01/18 19:05:29 - Copying Files... 01/01/18 19:32:32 - Installing Bootloader... 01/01/18...