System reboots after System Uptime

Hello all, I'm trying to get my first hackintosh to work. I am trying to run Mac OS Sierra (10.12.4) on a 6600k, GTX 1060 build. Whenever I try to boot, the bar goes about halfway and then comes up with the "System Uptime: ...". If I do verbose boot, it shows the same message. The computer then reboots after a few seconds. Any idea what could be causing this? I've tried looking it up and haven't had any success. What should I set my Mac type to in MultiBeast? Are there any kexts I need?

IronCraftMan said:

Hello all, I'm trying to get my first hackintosh to work. I am trying to run Mac OS Sierra (10.12.4) on a 6600k, GTX 1060 build. Whenever I try to boot, the bar goes about halfway and then comes up with the "System Uptime: ...". If I do verbose boot, it shows the same message. The computer then reboots after a few seconds. Any idea what could be causing this? I've tried looking it up and haven't had any success. What should I set my Mac type to in MultiBeast? Are there any kexts I need?

Click to expand...

I think your Clover Configuration is wrong...
You must have FakeSMC.kext installed, otherwise mac OS won´t work on non Apple hardware.
Also it could be that you must install SATA-100-series-unsupported.kext, otherwise you won´t see your harddrives. The kext is for skylake, but I heard that it also worked for KabyLake. Skylake and KabyLake are very similar, so you need to install this kext.
Also make sure that you disable your Nvidia card before the first boot, you can do it with "nvdisable=1" as a boot argument in Clover or unplug the card from the system.
When the installation is done you can re-enable the card.

Also make sure that you only have "other" folder under EFI/Clover/kexts. Make also sure that in this folder are only essential kexts that your system needs to boot up.

I think the best thing is that you upload your Clover folder as zip ( delete the themes folder before).