Yes, there is a way to set it permanently. I think it was in the plist file. But I can not check this information, because my new board does not boot in macOS, and I do not know why.
Yes, I see. And I wonder, because on the previous board it was working with security boot enabled. /-:
Yes, I think so. Perhaps we will find a solution later.
Thank You. And thank You (and the other) for Your help. :-)
When I am deleting the key, and sometimes goes wrong, I do not longer have a computer for my daily work. This is to risky for my. In this case I stop experimenting and buy an refurbished iMac with Nvidia graphics and use the PC only as GPU server.
With the previous ASUS main board I was able to...
Okay, I was restarting all from beginning.
Reset BIOS
set BIOS settings again (except secure Boot Mode, because it is impossible)
tried to boot from stick
Result: "Couldn’t allocate runtime area"
✅ If your CPU supports VT-d, disable it (found in Advanced/System Agent (SA) Configuration)
✅ If your system has CFG-Lock, disable it (found in Advanced/CPU Configuration/CPU Power Management Configuration)
❌ If your system has ****Secure Boot Mode****, DISABLE it (This is not possible with an...
Shut Down the PC (done)
Leave power cord in the PC (done)
Push the "Clear CMOS button" at the rear and hold it down for 5-10 seconds and then release. (done)
Restart the PC (done)
Enter BIOS Setup pressing the HOT key and (done)
Reset all BIOS Options to make it capable of booting Sierra USB...
Correct.
Yes I did. I used it on an other ASUS board. On Friday I get a new board and a new CPU. First I used a ASUS H110M-K, and now I am using an ASUS Maximus VIII Extreme.
The same error. I was able to boot into it for two or three times, but always with a couple of retries. Now it has the...
Thank You for the help. :)
I reset the BIOS to factory defaults (copied the untouched BIOS 2 to BIOS 1) and made these changes:
fast boot: disable
os type: "other os"
XHCI Hand-off: disable (correction: enable)
I plugged in the USB drive and connected only the SSD for macOS. The Windows SSD I...
Hi,
to get macOS to run on PC hardware is very frustrating! After the Apple logo the "do not enter" sign shows up, and I do not know why! Sometimes it bootes. But in 98 Percent it does not boot. :(
When I make a USB stick with Unibeast and try to boot from it I get always this "do not enter"...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.