Recent content by the66

Amazing, everything works now. Thank you all, especially you Mr pulpinex. I have another question. How can I get Windows into boot. He doesn't appear in it? And I did the benchmark test, I got better results on Mac than Windows.

efi

It's good I updated Sonoma to 14.4.1 with opencore 0.9.9, I can get Bluetooth but not wifi. Is there anything to do? And what should I re-check in the efi please

, thank you very much pulpinex. I changed the HDMI cable and everything appears. All that for a damn HDMI cable. I was able to install Sonoma 14.3.1 under OpenCore. 0.9.8.now i have to copy efi from usb stick and paste it into efi from sonoma disk. That's right ? And I would like to do the...

Yes it is installed. I can do it on the first boot by changing the HDMI port. But if I have to turn it off and then turn my PC back on, it boots and I get a black screen. And yes the LED flashes, and I have a signal to the screen, because it comes out of standby

Actually, to summarize. When I install Sonoma, I have to change the HDMI port so that I can see the screen to access the formatting of the SSD. Then when it restarts, I still have to change the HDMI port to access the installation. Then once the installation is complete, I still have to change...

I tested. It does the same to me. I only use agdpmod=vit9696 and I get this before the black screen

OK, I'll test all that and get back to you. And my mobo is Msi z790 p wifi, i9-13900k, radeon 5700 xt

How should I go about it. I'm lost at this level

In fact, Sonoma has not finished its installation completely. I have the Apple in white on a black background, and it tells me that there are 22 minutes left for the end of the installation.Then the screen goes black, and it goes back to the bootloader.

And when opening EFI with OX Auxiliary tools, I see an exclamation point in red, which gives me this error: OC VALIDATE :NOTE: This version of ocvalidate is only compatible with OpenCore version 0.9.8!


OpenVariableRuntimeDxe.efi is incompatible with FirmwareSettingsEntry.efi!
CheckUefi returns...

Hello, I downloaded and created the Sonoma USB key following message #118. The progress bar started to advance a little, and I still had the black screen. I then changed the HdMI port of the graphics card, and now I finally get the image. I then formatted my hard drive and install the OS. When I...

I used an older version of gibmacos, and was able to access the sonoma download. As soon as I create the USB key, I will get back to you. Many thanks again community

Excuse me. What I meant is I don't have Sonoma showing up