Recent content by randomrossity

I got it working! Dumb mistake on my end--I had the RAM frequency set to match the i5: 2400MHz, but once I changed to match the RAM 2666MHz, it worked. I only installed with one 32GB stick, then after installation I updated the config.plist to add another stick in the other slot. Then I powered...

Hmm.. I just removed the drive and used an old USB sata drive and still have the same issue. I also updated the memory section of the SMBIOS to look like this: Edit: I also just realized that my device is apparently a BOXNUC8i5BEK2, not BOXNUC8i5BEK1 (I'm in the US). Could that have any...

Thanks for pointing me to this @Leesureone! I missed this post. @vicantu, do you mind sharing what RAM you used and your config.plist changes? If you have the original file still, that's even better! I have a fairly similar setup, but with the NUC8i5BEK instead. I was trying the Samsung 64GB...

Thanks for the quick reply, but still no luck on my end. I was unable to downgrade the BIOS to any version. My BIOS settings match and Clover boots, but the macOS installer still fails. The switch to AptioMemoryFix.efi made the logging disappear, but now there's just a single row of...

Thanks for the great guide @Leesureone. I've been reading up on it for the past few weeks and finally got my NUC8i5BEK and have been eager to try everything out. I created my boot USB and am able to boot Clover, but it gets stuck right away after booting the macOS Install from the USB...