Recent content by llfreak

I also had trouble with my T6E, which started after installing 10.14.4. There is another thread where this was discussed. https://www.tonymacx86.com/threads/10-14-4-no-wifi.274360/ I replaced my T6E with a T9E (though it's the Rosewill version) and it works great. I believe something changed...

Have you found a solution yet? I'm completely stuck on this one. After a year of a problem-free experience, one update takes away my wifi. :(

So far I've tried the following. 1) Change the card to a different slot. (no wifi) 2) Add Lilu and AirportBrcmFixup to kexts/other (no wifi) 3) Revert to 10.14.3 (works) 4) Install 10.14.4 as clean install rather than upgrade (no wifi) Is there anything else I can try, or should I purchase a...

I'm having this same problem. The T6E worked perfect with 10.14.3, but after the 10.14.4 update it no longer recognized the hardware. So, I used my USB installer to wipe the drive and go back to 10.14.3, and it was working again. I decided to just remake my USB installer using the latest...

I finally got boot from drive working. I was able to use the 3rd solution in my last post -- using efibootmgr in Ubuntu -- to add an entry. It didn't work the first time I tried because it was creating an entry for the wrong hard drive. By default, it creates entries relative to /dev/sda, but...

I have finally been able to successfully boot my HS installation, but only using a custom Clover config and kexts rather than what was created by UniBeast. After being able to boot into HS, using USB, I used MultiBeast to install Clover to the EFI partition on my drive. However, attempts to...

Attached is a screenshot of what I see when booting from USB using the iGPU. Am I correct that my setup should work when using Unibeast to prepare the USB drive? What troubleshooting steps should I do next? I've gone through the entire process from scratch several times, so I feel that I have...

I pulled out my RX 580 and tried booting using the iGPU, but the same issue happens. I can't get past "ioconsoleusers gioscreenlockstate 3 hs 0". I set optimized defaults in BIOS again and then reset everything according to the guide, just in case I missed something when I did the last reset...

I can boot my install using safe mode, but without safe mode I get stuck at "ioconsoleusers gioscreenlockstate 3 hs 0". I see others having this issue and it seems related to the GPU. Do I need to modify my USB created with UniBeast in order to install Clover? I tried using MultiBeast in safe...

I reset my BIOS settings and started over, and was able to successfully complete installation. I haven't gone through MultiBeast yet so I don't know what problems are still ahead, but at least I got past install.

My hardware is listed in my profile. The only hardware I have that isn't listed in latest buyer's guide is my ASUS RX 580. I followed the installation guide for High Sierra. After booting from the USB created by UniBeast, my machine freezes very quickly. (I didn't select any of the options for...