I am using iStat Menus and noticed that the very few sensors are available. I would like to be able to display the GPU temperature. I also tried XRG with no luck. This leads me to believe that the sensors are just not active. Is there a way to enable these?
Sorry, for the delayed response. I am using the latest BIOS and for the settings I followed the instructions in this thread. No additional settings. Since, AFAIK, there are no differences between the 10900K and the 10900KF, other than integrated GPU, I would suspect the Samsung SSD...
The Dark Rock Pro is a tight fit but I did not have to change anything to get it in.
There is about a half inch between the fan and the ram.
The gap is small but it does not touch the card. I was able to get a butter knife (I know, not the best tool) between the heat sink and the card to...
Success! Followed the guide to the letter. Only issue that I encountered was that bluetooth on the Fenvi did not initially work. I moved the cable to a different on-board USB slot and it worked.
System boots from the selection of Catalina to the login prompt in about 12 seconds. I haven’t...
This thread inspired me to order the parts to build a new hackintosh. I will be using a 10900kf, 64gb (4x16) Ripjaws and a 5700 xt Nitro+. Not a big fan of AIO coolers, so I had ordered the Noctua NH-D15. Luckily I saw this and was able to cancel the Noctua and changed to a Dark Rock Pro 4...
I simply followed this mini-guide. You may want to double check your BIOS settings. As a note, I was never able to get this install working as well as I wanted, so I have since gone back to using my 6700k.
I followed your guide and successfully installed Sierra on my Asrock X99 Extreme4 and 5820k. I have two issues remaining that hopefully you can help with.
1. I have my CPU overclocked to 4.4GHz but Sierra is only showing it maxing out to 3.3GHz. By looking at HWMonitor it looks as though the...
I think you are correct. I have the same the same mobo and recently reinstalled 10.12.1. Using MultiBeast I installed ALC1150 and 100 Series Audio with no audio devices plugged in. On first reboot none of my ports showed up, but on the second reboot they were there. If I remember correctly I...
Using the link you provided https://bitbucket.org/RehabMan/os-x-eapd-codec-commander/downloads to Rehabman’s CodecCommander kext, I do not see the version you are referring to.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.