Recent content by kimcarsons

Don't think its the 8GB that's causing this - I've encountered this 'copy of apfs.efi failed' message many times - solution is to initially erase the USB key carefully - I have found Disk Utility is not reliable - ERASE and PARTITION processes (in 10.12) are not clear and certainly not fully...

these are unrelated clean installs starting with formatted drive each time 9 and 8 have no relation other than identical hardware Multibeast is not working for audio on X79 UP4 in Yosemite please describe correct procedure Realtek ALCxxx > √ ALC892 with or without Optional HDAEnabler (kext) >...

ok, toleda9.zip uses ssdt but what about toleda8.zip - on topic?

previous post shows all of above - file is toleda8.zip - do you find any clues there? meanwhile I have attempted a clover install successful boot with everything working fine, except poor USB3 functionality and of course NO SOUND i am beginning to think this is faulty hardware my sound is fine...

Thanks - files attached for green motherboard port (no sound) and USB adapter (sound!) (Extra/modules/HDAEnabler.dylib removed & re-boot)

OK, all requested files attached here, clean formatted install to recap for those following this thread; no sound output on any rear motherboard ports sound only possible through USB adapter 10.10.3, X79-UP4, BIOS F7, i7 3930K, ASUS GTX770 Multibeast 7.3 audio tested via mp3 playback on iTunes...

attached org.chameleon.Boot.plist yes i was booting with 0x3000 then switching to 0x2000 afterwards and testing back & forth another post mentioned there was a difference between using boot flags in the Extras folder manually at boot.. still no sound any suggestions?

Hi Toleda I'm back on this after a 3week break, determined to succeed IOReg carefully corrected - green,black & orange tested in correct sequence ***still no sound*** i am playing audio mp3 via iTunes through NAD amplifier and speakers - everything working fine with USB (IOReg attached) SSDT...

Yes after careful consideration i realize 15 out of 18 were a total :beachball: - thank you for clarifying. I have opted for another CLEAN install of 10.10.3 (i have updated my unibeast USB to latest Yos download) Attached info is with MultiBeast 7.3 - I hope this is correct for my setup and...

Audio ID =1

with Audio IDs: 1, 2 and 3 SPSOut/Internal Speakers > Green Port/Motherboard with Remaining audio output devices Audio ID: 1 SPSOut/Headphones > Green Port/Front Panel SPSOut/1st Line Out > Orange Port/Motherboard SPSOut/2nd Line Out > Black Port/ Motherboard SPSOut/Digital Out >...

none of my ports work with any of the audio devices! that's why I'm here. i am assuming that my green (Line Out) jack should correspond to Internal Speakers Built-in - as described there is NO SOUND, no crackle or hum my pink (Mic In) jack has also never responded in Yosemite - no audio input...

To be clear, I am testing every output (and input) on the motherboard (rear panel - my front panel is not connected - no case) I am using headphones that are known to work. iTunes is playing (although transport greyed out) sound is loud & unmuted - both in iTunes and in SysPrefs>Sound - I can...

... <ahem> attachments here ;)

OK thanks I've done another clean install and discovered a few more clues i) if I install MultiBeast 7.2 - Select: Drivers > Audio > Realtek ALCxxx > √ ALC892 but do NOT also select Drivers > Audio > Realtek ALCxxx > Optional HDAEnabler > Audio ID:1 then I have no Output Devices available...