Recent content by karog

Regarding Legacy PBRsata and Scan Auto=Yes. The latter just sets the key Scan to true with no other values and that was enough (without PBRsata which I cannot find documented) to get DefaultVolume to work. Thanks.

I was surprised that the HD Win 7 worked on the new machine since all the hardware changed but it did and has for months. Now the clone is the same machine, just from the HD to the SSD.

Thanks for the response. Didn't mean to hijack a thread. This one was titled Cloning old Windows Install which seemed appropriate. The HD Win 7 was from the main drive in another Hackintosh that died. I built this new one with SSD, installed Yosemite, and added the HD. Chimera found the...

I have Chimera and Yosemite running on an SSD. I also have Windows 7 on an attached HD that boots with the same Chimera. I want to migrate the Win 7 to the SSD. I created a new partition on the SSD, formatted it to NTFS and cloned the Win 7 to it. But when I try to boot it, I get the \Boot\BCD...

I would suggest that you do not clone your disk but rather install Yosemite according to the installation guides on this site and then use Move your content to a new Mac

Try iMac 14,2 which is recommended if you are using graphics card or graphics card and Intel on chip graphics. If using Intel on chip graphics only, use iMac 14,1. As you can see on the left, I have pretty similar to you and this works.

I would start from scratch. Removing kexts isn't so hard but some of the choices in MultiBeast do other things so you have to look at each one and figure out what to do. That is why sometimes starting over is best when you haven't got much invested in a running system. You are still in the early...

Try removing all of the following from your list: Drivers > Misc > NullCPUPowerManagement Drivers > Misc > VoodooTSCSync > VoodooTSCSync 4 Core Drivers > System > AppleRTC Patch for CMOS ResetBootloaders > Chimera v4.1.0 Customize > Boot Options > PCI Root ID Fix Customize > SSDT Options...