Yesterday I even replacement the sata cable. It is based on the same model of MacBookPro2011 but can use SSD. There is no problem with the cable.At present, I can only suspect that it is the logic board of MBP
The SSD is installed internal of the MBP. Using the Disk Utility and the terminal diskutil command, the SSD cannot be found as if it does not exist.
SSD was changed to SATA 2.5 hard drive >>> It can be recognized normally and the system can be installed smoothly. There is no problem with the MBP...
Hi,
As i known apple imac no longer offer function of Target Display mode offically in NEW model and NEW macOS.
But I still like to know if the iMac5k can operate in TDM (Target Display Mode) lately.
Below is my attempt:
imac5K-1 with 2015 late i7-6700K & amd m395.
iMac5K-2 with 2015 late...
Host: iMac 5K 2015 late (iMac17,1)
Boot: OCLP 1.4.2
cpu: i7-6500
gpu: amd m380 2gb
igpu: Intel HD 530
System: macOS 13.0~13.6.5
After reinstalling the newly installed macOS, the screen is stuck on the Hello Welcome screen.
When I press any key on the keyboard and mouse the screen will flash...
Hi,
maybe you would like to try this:
Nightly.link: OpenCore-Patcher.app (Sonoma Development)
reference: https://github.com/dortania/OpenCore-Legacy-Patcher/pull/1077#issuecomment-1646934494
me too, It will boot and say "Hello" but will not start setup and then repeat again and again.
I gave up on macOS 13.6, finally.
Installing and running macOS 14 release is very well in my case.
Thanks!
DELL Optiplex 9010MT
cpu: i7-3770
ram: 24g
gpu: rx560 4g
ssd: micron mx500 1tb
source: macOS installer 14.0(23A5337a)
Hi!
maybe the following will help:
step1
To get a efi which could run macOS 12.x.x successfully.
Step2:download and add CryptexFixup.kext to config.plist and kexts folder...
Hi!
maybe the following will help:
step1
To get a efi which could run macOS 12.x.x successfully.
Step2:download and add CryptexFixup.kext to config.plist and kexts folder
Step3:add "-amd_no_dgpu_accel -cryptbeta amfi=0x80 ipc_control_port_options=0 amfi_get_out_of_my_way=1" to boot-args in the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.