Recent content by jimbojingle

  1. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    No, I used Apple App Store and then createinstallmedia. Would that make a difference?
  2. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Had the very same problem trying install fresh from USB. I have now given up for the time being.
  3. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Thanks, Unfortunately I still have the same problem after many attempts. Perhaps I should try a fresh install to a new SSD from USB stick.
  4. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Thanks again. I have done as you suggested. Unfortunately, I am still getting a reboot loop when I select macOS Installer from the Boot Picker Menu.
  5. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Thanks. This section was not appearing. I must have used an older version of the Configurator. Unfortunately I have set SecureBootModel to disabled but my partially upgraded Sonoma SSD (from CCC Backup of Ventura) is still in a reboot loop when I select macOS Installer from the Boot Picker...
  6. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Hi, I see you have already updated the instructions as Trepamuros had a similar problem to me. Unfortunately, I cannot find where to set SecureBootModel to Disabled. I have looked in config.plist in Misc/Security but its not obvious to me. Please advise. Thanks.
  7. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Hi, I have just tried to upgrade from Ventura 13.6.5 to Sonoma 14.4 using a CCC SSD bootable backup of my Ventura NVMe and it goes part way through the install and then goes in to a reboot loop when macOS Installer is selected to complete the installation. Any ideas what may be causing this?
  8. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Hi All, I haven't been around for a while so haven't been keeping up with current posts. Just wondered how straightforward it is to upgrade my Z490 Vision D + RX 5700 XT from Ventura 13.6.3 to latest Sonoma. Any pointers would be appreciated.
  9. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Hi all, What is the current recommended use NVMe for the Z490 Vision D? I currently use 2 x Corsair MP600 1TB NVMe's and would like to upgrade to 2 x 2TB NVMe's. Thanks
  10. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Thanks, I have tried switching the Network Filtering off with no success. I will try uninstalling. It's strange because all works well for an undetermined amount of time and then I suddenly lose Internet Connectivity. Then it is restored after a System Reboot but again all is good for a period...
  11. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    I am using Little Snitch Network Monitor but even with the Network Filter Off, I am still experiencing the same problem. That means, Little Snitch isn't blocking any connections and it still doesn't work.
  12. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Thanks. I have rebooted my Cable Modem and eero Pro Router but still not Internet Connectivity unless I run my VPN. The VPN provider suggested I change my DNS setting to 8.8.8.8 rather than the Router IP Address but this had no effect either. It was working ok until recently possibly after...
  13. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    Hi, I have a weird problem on my Z490 Vision D. I am running Ventura 13.3.1 with OC 0.9.1. I keep losing Internet Connectivity when connected by Ethernet or WiFi. If I run my VPN, Internet connectivity is restored. If I reboot, Internet Connectivity is restored (Ethernet or WiFi) but only...
  14. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    I have disabled VTd in BIOS, and the Ethernet and WiFi connections were restored. However, Internet Access keeps dropping out even though Ethernet and WiFi Interfaces are still connected.
  15. jimbojingle

    Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

    I, too, have lost Ethernet and WiFi after upgrading to Ventura 13.3. Please advise how do I disable/enable AppleVTD? Thanks.
Back
Top