Recent content by Jelleko

Anyone?

Hello, I managed to install mavericks onto my computer. However, i can only boot it with safe mode. Do i need an DSDT to het everything working properly? As of this moment, Graphics are flickery, the computer will only boot in safe mode, and the audio is not working. I already tried some...

Hey miniITX, i tried your attached DSDT on a separate HDD, unfortunately i have the same issue. Maybe you have suggestions for additional multibeast settings?:) greetings, Jelleko

@miniITX sorry for my late response, i was very busy at my university. i extracted the DSDT this time, after i removed the DSDT in the extra folder. greetings :)

unfortunately i have tried that function in multibeast as well :( i have managed to get everything else working except that darn hd4000, haha. any other suggestions? thanks

I tried and tried, but still no luck :(

@miniITX, I extracted the DSDT, thank you very much for your help! :)

@MiniITX, My specs are as follows : z68 pro3 gen3 with 2.30 bios ( from samisnake ) Nvidia Geforce gtx 285 ( recognized and fully working ) intel i5-3570k with hd4000 in bios set to 64mb ram. and further 8 gb ram and an 60gb SSD. Greetings, Btw MiniITX you have a nice and tiny itx build!

Hello, i am using a i5-3570k on this board. unfortunately i can't get the hd4000 graphics to work. i have set the internal graphics memory size to 64 mb, and followed this guide : http://www.tonymacx86.com/150-enabling-hd-3000-graphics-7-series-motherboards-hd-4000-6-series-motherboards.html...

I tried this guide: http://www.tonymacx86.com/150-enabling-hd-3000-graphics-7-series-motherboards-hd-4000-6-series-motherboards.html But it didn't work :(

Anyone? i can't figure out how to use my hd4000 on an 6-series mobo :(

Minihack, in what way do i perform the patch? Toleda, Yes i am using GraphicsEnabler=yes, i had it set to no for a while, but i have set it to yes now. I am sorry, i am a bit of noob at hackintoshes ;)

I think i have my bios setup correct, Do you have any suggestions? At system report it says it sees a graphics card with 64 mb, but without a kext. Do i need to follow the steps which involves these steps? Device (GFX0) Method (_DSM, 4, NotSerialized) {...

Thanks! so by the look of it, i only need to change the Boot.plist to GraphicsEnabler = no?

Hello, I have a Nvidia geforce gtx 285 which is recognised by mountain lion (10.8.4). It is working successfully with all acceleration for graphics. I have it connected to one of my two screens. On the other screen i connected my hd4000 from my i5 3570k. unfortunately the hd4000 isn't...