Recent content by jazz0420

I had SIP disabled the entire time. 0x67

I used my old ATI HD6870 to boot and clean install 10.13, installed Nvidia Webdrivers, Ran AGDPfix.app, installed Lilu and NividiaGraphicsFixup in Clover other folder, used KextBeast to install NVWebDriverLibValFix.kext to L/E, Ran Kext Utility to fix permissions. Rebooted and verified working...

I would try Do you have a older ATI graphics card by any chance? You will have much better luck with the install!

I used my old ATI HD6870 to boot and clean install 10.13, installed Nvidia Webdrivers, Ran AGDPfix.app, installed Lilu and NividiaGraphicsFixup in Clover other folder, used KextBeast to install NVWebDriverLibValFix.kext to L/E, Ran Kext Utility to fix permissions. Rebooted and verified working...

Success on a X99 Asus Sabertooth, i7 6800k, 16GB 3000MHz RAM, EVGA GTX 1050, High Sierra 10.13 Supplemental Update, Nvidia Web Drivers. Great Guide!! Thx!

Anyone have any ideas on this, Everything was working fine in 10.8.2. After the update the HDMI output doesn't work even though it's recognized under displays and sound. Doesn't make any sense. I was using a modified ati6000controller.kext on 10.8.2. Maybe someone could patch the 10.8.3 kext for me?

I have a 4 port Sapphire HD 6870 working on 10.8.1 with the modified kext Toleda posted. Can anyone edit the 10.8.2. kext?

I'm using a modified Ati6000Controller.kext for 10.8.1, now that 10.8.2 is out, it has a new Ati6000Controller.kext. Could someone modify the new one like the old one plz? Thanks!

Try this...

I got it working now thanks to Toleda. Needed a modified ATI6000.kext 100% now with Duckweed framebuffer loaded.

Thanks!!!! 100% now!! You are a great man!! :-}

GE=Y - No HDMI, everything else good Duckweed/GE=Y, 1. Just HDMI black screen after boot 2. Upper DVI works fine 3. Lower DVI works fine 4. I have a active DP to DVI which I used a DVI to HDMI, and it worked fine, even with upper DVI plugged in. No sound..

I have a LG LED monitor going through top DVI port with a DVI to HDMI cable 1080p. Then on the HDMI port I'm running a Pioneer Elite Receiver also 1080p. GraphicsEnabler=No AtiConfig=Duckweed gets me everything working, except the card shows up as Radeon HD 6xxx. GraphicsEnabler=Yes...

Well, I did what you said, and now all is good! What do ya know... On a side note, I have to boot with GraphicsEnabler=No to get anything to come out of HDMI. GraphicsEnabler=Yes gets me full card recognition in system information but looses HDMI output. Any ideas?

I battled with that card too. I boot with GraphicsEnabler=No AtiConfig=Duckweed and a custom DSDT. I have two monitor working with top DVI and HDMI. HDMI has working audio as well. Full HW acceleration.