Recent content by jarvise

Hello again Would it be nice to change the smbios from 18.3 to iMac 19.1 with the update 10.14.5?

if the USB 3.1 gen 2 works, that port is not inside the SSDT

I also leave my config.plist if it is useful for anyone and also if I have something wrong in my config.plist to me at the moment everything works perfectly

Hello I finally had a moment to pass the SSDT of my Motherboard in the frame images the ports that are working In addition, the USB port for the Wi-Fi and Bluetooth card is working I leave everything here in case it serves for someone To me, works perfectly

Hello again Stork in your private conversation I get that "You need to have 75 posts to be able to see your conversations." and I can not answer you How can I contact you?

So is it working correctly, right? and all the kext that I mentioned in the previous post are correct

Hello Stork I have a problem in about this mac in the SATA / SATA Express section I see generic AHCI Controller I need some kext or is for another reason Or would you be so kind to tell me for the motherboar Asus maximus x hero wifi ac that Kext are the ones you need? in these moments I have...

I believe that everything is correct I leave my SSDT and ioreg to give me his approval and another question I have is to know if my safire RX580 is working with the good drivers, I have in clover / Graphics / FB NAme Orinoco and INJECT ATI INJECT Intel and I have Lilu.kext and...

That was what I was asking but the USB 3.1 ports, the typical 3.0 pen, work on all USB ports, but the HDD 3.0 only works on some ports Could you tell me why?

Excuse me, I'm telling you, I do not get along with English I told you that now I know where I have the USB 3.1 the question is that if I have to put in the new SSDT the HS01,02 .............. and the SS01,02 .............. or just put the Hs or otherwise I put only the SS or do they both?

I already managed to start with -uia_exclude_hs all right Now I have a question the USB 2.0 ports I only have in HS the 6 USB 3.1 ports I have both in HS01.02.03.04.05.06 and they are the same in SS01.02.03.04.05.06 match I have to put the HS and SS in the SSDT or which of the two dev's put?

I'm really sorry but I read the post 1 thousand times otherwise I would not ask and do not know Next, we boot with -uia_exclude_hs uia_include = HS03 to test SSxx and USRx ports Should we put it somewhere clover? to start Excuse me but I'm Spanish and I do not get along very well with...

I think where I get lost is in the section where you have to check with -uia_ignore_rmcf the xhc 01,02, 03 etc if I have them checked but I do not know how to detect ss01,02,03 etc I do not know the translation or I just do not know how do I detect the SS01,02,03,04 ............

Hello again after starting again from the beginning now all USB ports and Charge devices work? but only the USB ones are seen. 2.0 USB 3.0 devices are not mounted What I can be doing wrong? I leave my ioreg and SSDT-UIAC

Hello According to the Rehabman guide I have all the USB ports of my motherboard already configured, except USB TYPE C As I do not have any TYPE C device, I do not know where they are here I leave my SSDT-USB in case someone can tell me what would be the missing I have the SSDT-USB.aml...