For several days I have tested several variations of patches in config.plist / ACPI / DSDT / Fixes and config.plist / ACPI / DSDT / Patches.
Unfortunately none of them had a positive result. The following screen is always displayed after the installer boots:
Com.apple.WindowServer Service only...
I tested without Nvidia patch and without EC0-> EC patch. However, the same problem remains: Com.apple.WindowServer Service only ran for 0 seconds. Pushing ...
Only the patch to disable nvidia has been applied.
SSDT-12:
into method label _OFF parent_label \_SB.PCI0.RP05.PEGP code_regex .*EC.* removeall_matched;
SSDT-11:
into method label _INI parent_label \_SB.PCI0.RP05.PEGP insert
begin
//added to turn nvidia/radeon off\n...
Solution found.
First I would like to thank @lingering2012 for having discovered the solution and @RehabMan for giving me all this time support and created the patches.
Basically nv_disable = 1 is not working in the correct way having problem on system startup. The solution is to apply the...
I formatted my external hd and I did a clean install of the High Sierra Beta 7, using my desktop. It has been successfully installed and can boot normally on my desktop. I installed FakeSMC.kext using MultiBeast 9.2.0.
I restarted the computer with the -s flag, I executed the command: kextload...
I tried several times to load FakeSMC.kext manually but still with the same error.
Today I updated to beta 7. It continues with the same problem but now a new message is appearing:
On the main system(Sierra) I executed the following commands:
sudo mkdir /Volumes/External-HD/kexts
sudo cp -R /Library/Extensions/FakeSMC.kext /Volumes/External-HD/kexts
The ¨kexts¨ folder and the ¨FakeSMC.kext¨ file were successfully created on the external hd where High Sierra 10.13 Beta 6...
Can a permission problem occur when I run the commands on another operating system?
In case the target volume is the external hd but I'm creating the kexts folder and transferring the FakeSMC.kext using internal system (10.12.6).
@Hugotai I currently use Mirone's Audio Patcher. Both the...
KextLoad from System / Library / Extensions. Was FakeSMC loaded?
CsrActiveConfig is set to 0x67, the SIP should be completely disabled.
Is it possible to use the graphical driver from the previous beta?
I tried loading the kext manually but gave an error:
After the exit command, I could see that "DSMOS has arrived"
But it can not boot properly:
Obs: Beta 6 is currently being used.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.