I have VT-d enabled in BIOS and have dart=0 removed and the machine is working just fine. I can't find one person who has actually gone out and done this but have seen many who have made it work under Linux.
I have been constantly working on this machine and have gotten to the point where all the Apple power management kexts are able to run on my system without causing any issues. Except for the fact that my system is always running in the lowest multiplier and I still can not get it to sleep. I am...
I have been constantly working on this machine and have gotten to the point where all the Apple power management kexts are able to run on my system without causing any issues. Except for the fact that my system is always running in the lowest multiplier and I still can not get it to sleep. I am...
Ok so I looked into my crash logs and they all say either the UserEventAgent or that my GPU reset. How do I fix this? Is it caused by a bad clover configuration? This only happens if I enable Apple's Power Management.
Title. If I remove this kext I am able to boot the machine but about 30 seconds - 1 minute later the machine will lose video signal, my 5770's fan will spin up, and it will reboot. I have tried combinations for my config from...
So I believe I set up my clover config correctly (Which is included in this post) but my machine still will not sleep correctly. When I click sleep the monitor will turn off but my machine will stay on like I didn't do anything. Is there something i'm missing to make this work properly?
Hi. I'm new to this hackintosh thing and am in need of some assistance. I don't know if I have set up my clover config correctly because I am unable to sleep or get turbo boost on my setup.
SuperMicro X8DTE
Intel 2xX5550 CPU's
4x1333 ECC DDR3 4GB
AMD/ATI Radeon 5770 1GB
I have included my...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.