Recent content by DWegmann

Hi, I installed OS X 10.11.5 on an NUC6i5 with the 44 BIOS and using an 4k Asus PB287Q via DisplayPort. It is working great but I have one problem: If I turn the display off and on again I get a black or no signal screen and it looks like the mac is freezing. The only choice I have then is to...

So, I tried it out. I had to use my MacBook Pro because I was missing a special cable to connect the output HDMI of my switch to the NUC. So the setup was the following: My MacBook was connected over the HDMI port to the switch. The output of the switch was the TV. The switch had only the...

My MacBook Pro has also only an internal graphic chip. I would also say it has something to do with the display driver in OS X. When I had this problem at that time I also searched the internet for any solution to this problem and found a few post which mentioned the same problem but no solution...

The MacBook I tried before 13" MacBook pro retina (mid 2014), and two other displays as I use currently. My current configuration is that I use a 4k monitor on the display port for normal work and an additional 1080p tv with the HDMI port. Often I use only one of them so this problem occurs...

I have the same problem. My little workaround for this is that after I turned one display off to plug-out and plug-in the HDMI or display port cable from the NUC. My NUC is on my table so this is easy. I had the exact same problem early with my MacBook Pro when I was using two monitors and...

[Guide] 10.11 on Intel Broadwell NUC 2.0 Hi, I just installed Mac OS X on my i3 NUC with your guide. Thanks a lot for that. It looks like all is working fine. I use the NUC with a 4k Asus PB287Q monitor over DisplayPort and it looks like all resolution and scaling options are working.