Recent content by dvandriesen

How did you make out? I have a H61N-USB3 i need to update but always afraid to update since always issues.

Got myself up and running after a lot of reading. Clover is very nice finally switch over. Took a little getting used to but everything seems to be working decent. Only issue I'm working on is sleep issues but other then that seems pretty stable. Thanks for your hard work for the community tony.

El Capitan GA-H61N-USB3 Reboot Loop Those pics look little different I used clover configuration. I figured it out and was able to get usb3 working I think with the dsdt that someone linked in the forums. Thanks for your help though.

El Capitan GA-H61N-USB3 Reboot Loop Got it figured out. Had to work quick mount efi and drag and drop my config.plist into location. Then fired back up ran clover installer and installed my dsdt.

Think i might have figured this out working on installing those DSDT since i have no sound.

Frist time switching over from Chimera and followed all the switching over guides. Followed the Clover install and was able to get everything setup without the USB stick. However with Clover Config I ran and set it up as 3.1 mac pro moved over the downloaded conf.plist and now stuck in a...

No luck for me I am able to get it to load up without USB but it restarts fairly quickly. I usually use Mulitbeast this is my first time with Clover so not sure what Im missing.

Seeing as you guys have the same MB as me i will ask here. Finally got it to fire up without usb didnt change my bios settings to HD first. However in about MAC my Graphics are showing up HD 2000 3MB. Any help getting that straightened out ?

Did you use uefi or legacy boot ??

I have the same motherboard as you. Haven't updated yet as I always have used multi beast. Hope mine goes smooth I'll make sure to turn off usb3.

Worked now. Needed to use -x to finish the build and then ran multibeast and just did audio will report back if have any issues thanks.

Have done around 5 reboots and system has been ok once it reverts to the 7mb i will post this ioreg as well to see if you can assist with seeing difference. Thats a little out of my league. Thanks for the help so far. On this install i used the stock DSDT for my firmware as i have seen other...

Here it is working correctly except my hdmi audio i havent messed with. https://www.dropbox.com/s/at4dlvmpbcm8n5l/Mac%20Pro%20yosemite.ioreg?dl=0

Will give this a try. Been having alot of issues with my made custom DSDT with the hdmi already put in it. Problem im having is my HD 300 starts at 512mb and drops to 7mb after a reboot or two. I tried using the regular F8 DSDT now we will see if that fixes this issues.

Thanks for reply. I will do my best to get those results on this next clean update.