Recent content by daniel-c05

I updated to 10.9.5 directly and now I'm stuck on a bootloop. Intel HD 4600 Core i5 4570 Intel DH87RL Using Clover Any ideas on how I can go back to 10.9.4? Or how I can address the Loop? It's worth noting that I am booting with -vx but I can't really tell where problem is coming from.

So I finally managed to get the system to recognize the integrated graphics. I had to: a) Use the default config.plist instead of the specific one for the HD4600. b) Use an HDMI cable for my monitor. Using the VGA got me a black screen. I will however report that I still get bad screen...

Hey Guys, I have an Intel HD 4600 Integrated here that apparently doesn't work properly. I used the attached config.plist for the HD 4600 but while the system detects it, it doesn't seem to fully use its power (It only uses 7MB of VRAM). I have some horrible flickering on native apps and...

After a whole week of multiple installation attempts, and lots failures, I finally managed to get Mavericks Installed. I ended up going with Clover after Chameleon and Chimera failed to get the job done with my hardware. Here's the guide I followed...

I managed to get OS X Installed, and the system had the 1st reboot; i then selected the usb again on the bootmenu but I still see the same "Install OS X" screen, and nothing happened as mentioned here: "The system will boot into the new drive, create the recovery partition, and complete the...

[Solved] Problems Getting 10.9 Mavericks on Haswell Intel DH87RL Hi Guys, I'm having a ton of issues, with mostly everything since I started trying to get my Hackintosh going. First off, my setup: Mobo: Intel DH87RL CPU: Intel i5 4570 Hard Drive: 750GB SATA. Graphics: Intel HD 4600...