Recent content by d3nnis

Cool ...

i dont think any issue ... but its not the latest

fyi i use the following bootflag slide=0 -disablegfxfirmware hope it helps ... using the BCM943602CS card though

thanks ... solved my problem and successfully updated :)

same ... in a kind of loop... install but failed , reboot tried to update again but failed again

When setting up MultiBeast, did you include under Drivers->Audio , AppleALC?

For BIOS I followed the guide available on this site, something like below 1. To access BIOS/UEFI Setup, press and hold F11 on a USB Keyboard while the system is booting up 2. Load Optimized Defaults 3. If your CPU supports VT-d, disable it 4. If your system has CFG-Lock, disable it 5. If your...

And I disabled both serial and parallel ports, too.

i follow the ROM settings in the installation guide (https://www.tonymacx86.com/threads/unibeast-install-macos-mojave-on-any-supported-intel-based-pc.259381/#uefi_settings) If your CPU supports VT-d, disable it. If your system has CFG-Lock, disable it. If your system has Secure Boot Mode...

it's in the EFI.zip file

Sorry, I did not check the amount of VRAM after installing High Sierra ... as I put in my RX 580 after the system running fine.

Yes, I am running Mojave (10.14.3) now. What I did initially was I installed High Sierra using the UniBeast with the onboard graphic card. Then I upgrade to Mojave.

rx580 is good hahaha

try this guide https://www.tonymacx86.com/threads/an-idiots-guide-to-lilu-and-its-plug-ins.260063/

please see post #4 , I attached my EFI there