Recent content by ChrisTheEngineer

Hey Stork, I wanted to update this thread to let you know that I got it working a little while ago. I turned off BootCamp just in case. I found that my issue was that I did not format the USB as EFI before I used UniBeast (I did the normal format, but not EFI through the terminal). I didn't...

Thanks, I'll check that out. I did notice something strange though. My current Macbook is running High Sierra, and has Bootcamp enabled with Windows 10 on the partition. I created the Unibeast USB on this Macbook, I noticed today that when I try to access my Windows 10 on Bootcamp, that Clover...

Hey Stork, I'll look into multibooting. Though, I did try disabling the windows booter and SSD that windows 10 lies on. It flashes like before but ends up going to BIOS.

Hey Stork, It looks like I'm getting closer. I went ahead and bought a 16GB drive and created the boot USB from that. I am no longer getting the error. However, I am not getting to clover yet. When I boot from the drive, the screen flashes a few times (very quickly, but it seems like there a a...

Hey Stork, I made sure to try on all USB ports including the BIOS flashback port. I am using a SanDisk Cruiser Dial 32GB as the usb. I tried recreating the boot USB a few times (I would reformat, give it the name USB). Then I would run Unibeast, and it seems to me that it works correctly (no...

Hey Stork, so that is correct. I did not get any error messages when I used UniBeast to create the installer. I got High Sierra through the app store from a macbook running the same. Steps I did: Followed the tonymacx86's guide to create Unibeast (no errors) added additional programs to the...

Hello I have followed these steps, but when I try to load the USB i get "Missing operating system" and never reach Clover. I'm not too sure what to do. Any suggestions?

Hello, I just built myself a computer where I would like to dual boot windows 10 on one drive, and hackintosh (High Sierra) on the second. I would like to switch between those (not sure how to go about that yet). Below is my current build, any help on getting me started in what I should look...