Recent content by blassley19

am i the only one that is experiencing "freeze ups" when i try to watch any kind of movie or even youtube

****UPDATE**** after roughly 4-5 hours im seeing lines again... i hope the Team fixes this "hopefully with mountain lion"

****UPDATE**** i tried with kernalcache disabled and my computer is going slow idk if its becuase of my overclock but, on a good note my screen artifacts are no more, been 2hours of testing.

thanks Inspector42 i am trying your idea now. will let you know how it goes.

has anyone found away to get rid of these screen artifacts with intel hd 3000.. i have try many ways i turned my over clock off, no results tried FakeSMC v4.2 no luck tried with the HW monitor tool and still nothing also tried with 4gb ram instead of 8, and tried "tweaking" the VRAM.. if anyone...

i don't think its your board that is the Problem check the Graphic Card wiki and make sure yours is supported trust me i know how you are feeling at this point we have all been there, don't give up. :D, personally I'm using intel HD 3000 because its the easiest route it works fine just change...

i had this problem set bios to defaults recheck over everything, sometimes it helps if u take out your RAM "if over 4gb" until after multi beast also try boot flag GraphicsEnabler=No

i have been testing OSX 10.7.4 on my system over clocked to "extreme" and it works great and gets rid of my Screen artifacts system: GA-H61N USB3 core i3 8gb ddr3 UPDATE****TP-LINK TL-WDN4800 works OOB "Native Airport :D Screen Shot 2012-07-17 at 3.19.41 AM.png kext that i installed: FakeSMC...

i followed the guide to use the update combo but once i go to instal the combo update the update fails...? does anyone know a solution.. http://tonymacx86.blogspot.com/2011/07/ ... -1068.html used this guide^