Recent content by ax42

Update: It works now (and I unfortunately can't pinpoint why). I was following this guide (and the lnx2mac one linked in it): viewtopic.php?f=7&t=6616 Was being nice and careful, one setting at a time, and then started getting panics on boot. When I went back into my BIOS, I am fairly sure...

Hi Is there a BIOS setting or something I have to do to get FW800 working? I started with a PCIe card recommended on the forum here for working OOB: http://www.amazon.com/Syba-Profile-PCI- ... cx86com-20 That didn't work, so I tried a PCI one: http://www.amazon.com/SD-LP-TIFWB-Profi ...

Did you run Bridgehelper again after the update (on Ivy Bridge)?

I bought that card (the PCI-e one) and it is only half-working. FW400 seems to work OK, however FW800 seems dodgy. If I plug a drive into the FW800 port, system profiler says: FireWire Bus: Warning: Unable to list FireWire devices. Maximum Speed: Up to 800 Mb/sec And in console I get...

Sorry, I should have responded to this. It all worked fine the next morning, and I pumped around 200Gb of data backwards and forwards across the network during the final setup, so it seems to have fixed itself. The computer has been working like a charm ever since. Just for reference in case...

Running a Z77-DS3H board, i3570 (not over clocked), 16Gb RAM and a GTX570. Installed with Bridgehelper 5 + UniBeast. Most things seem great, except the network is very wonky. I've installed maolj's Atheros driver in Multibeast 4.6.1. Internet seems to work fine, but connections to other macs...

Hope someone has an answer to this -- I have just bought the parts for my Hack and will be in the same boat as I also have the 27" 2560x1440 Dell Monitor.