Article: OS X 10.8.5 Update
Have successfully upgraded to 10.9 Mavericks 10.9 and also applied the 10.9.1 update. However had to do a Unibeast install from scratch and restore/reinstall apps. Not to bad if you have a Time Machine backup or use migrate utility if you have the 10.8.5 system...
VTSIM, just make sure and install the latest version of Chameleon first, 2.2.1 is the latest right now. Then make sure and use the NVRAM 1.1.2 file. If you need more help just go to the original post discussing the solution in detail...
The thread supplied in this post worked for me, just don't use the newer NVRAM 1.1.3 file. Use the NVRAM 1.1.2 file. Thanks for the help.
Here's the link to the post for help again.
http://www.tonymacx86.com/general-help/110471-how-fix-imessage.html
Hey Thanks for the post. I set my BIOS settings the same:
Init display first: PEG
Enable Internal graphics: Yes
Internal graphics standby mode: No
Internal graphics deep sleep: No
On my Gigabyte GA-Z77X-UD5H board and tested, works great.
iMessage poll
I have three Hackintosh and all three have a non working iMessage. One of them I have not used iMessage for 2 months and logged itself out and now it gets the can not register message. One of my machines is 10.8.1 ML and was working, it's machine I use for backup other work...
I had simliar problems with the audio with a similar setup. But when I did a fresh build with ML it worked great when I did Multibeast with the No-DSDT and Patched AppleHDA for the 898 audio. Doing them at the same time seems to be the trick. Thanks for the post and helping me with my audio...
6870 Tri Monitor Working
Thanks "trickybreeze" I followed your link and explanation and BAM it works great on my XFX ATI 6870. Thanks man. Buy the way this is running on a Z77/Core I7 Ivy Bridge motherboard/CPU and a ML installation.
Works great!!
Tried Everything - Try this
I have a a GA-Z77X-UD5H mother board with two NICs. I ran into the problem as it's been described where the Ethernet interface shows up as EN1. When this happened I was unable to use iCloud or Appstore got the unable to logon to account message, as described in...
Hey Thanks Jon V you are awesome. I've been looking how to fix the EBIOS Read Errors for many months. And your advice to disable the USB Storage function worked!! Thanks dude. I think you can still boot since it said it was a legacy mass storage function, sounds like it's support for an...
I have the same problem, at boot time chimera hangs at the spinning bar before it gets to the OS boot screen. After system reset once it boots up fine without hanging. I updated Multibeast to 4.0.3 and Chimera to 1.6 but no change. I'm running the latest version of the DSDT file a well. Any...
Newbie to doing a build. I have OSX running on 10.6.8 and boots up fine on iboot. But when I boot after I do a multibeast configuration it freezes with a black screen after I get the apple screen. I booted in verbose mode and here is a pic of the screen just before it locks up. Any insight...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.