- Joined
- Nov 30, 2012
- Messages
- 11
- Motherboard
- Intel
- CPU
- q6600
- Graphics
- g41
- Mac
- Classic Mac
- Mobile Phone
So I build a dual boot system (windows 7 / ML 10.8.2)
Everything is working except for 1 problem that I can't found any answer to. The issue I am having is whenever I do a reboot or a cold boot and get to the desktop, I could move my mouse and see the cursor, but there are no clicking or pressing any key on keyboard (Command Tab and etc). However after a few minutes (4-5mins) later the clicking and keys works.. I don't know why is there a delay.
In 10.8.0 the cursor don't even show up at boot until a few minutes later.
Now this is the same for USB and bluetooth keyboard and mouse. I know the system is not freezing because I have leave youtube video on and it runs. Also in System report under USB it see keyboard and mouse. Also if I use teamviewer to login I could click and right click though it, but not using the physical hardware.
Any help will be great.
My setup is as follows
Gigabyte H77-DS3H v1.1
Intel i3 3220 Ivy Bridge
Kingston 8GB DDR3 1600mhz single Stick
PNY Nvidia GT 210 with Dual 1080p screen
OCS Vertex 3 120GB
Pioneer Blu Ray Drive BDC-207D
Thermaltake 350w
I install ML using
Unibeast 1.5.3
ML 10.8.0 Retail Disc Image
Multibeast 5.2.1 Installed
-UserDSDT or DSDT-Free Installation
-Realtek ALC888b/887 with DSDT and without DSDT
-Nvidia Fermi Patches
-Trim Enable
-Atherors
Everything is working except for 1 problem that I can't found any answer to. The issue I am having is whenever I do a reboot or a cold boot and get to the desktop, I could move my mouse and see the cursor, but there are no clicking or pressing any key on keyboard (Command Tab and etc). However after a few minutes (4-5mins) later the clicking and keys works.. I don't know why is there a delay.
In 10.8.0 the cursor don't even show up at boot until a few minutes later.
Now this is the same for USB and bluetooth keyboard and mouse. I know the system is not freezing because I have leave youtube video on and it runs. Also in System report under USB it see keyboard and mouse. Also if I use teamviewer to login I could click and right click though it, but not using the physical hardware.
Any help will be great.
My setup is as follows
Gigabyte H77-DS3H v1.1
Intel i3 3220 Ivy Bridge
Kingston 8GB DDR3 1600mhz single Stick
PNY Nvidia GT 210 with Dual 1080p screen
OCS Vertex 3 120GB
Pioneer Blu Ray Drive BDC-207D
Thermaltake 350w
I install ML using
Unibeast 1.5.3
ML 10.8.0 Retail Disc Image
Multibeast 5.2.1 Installed
-UserDSDT or DSDT-Free Installation
-Realtek ALC888b/887 with DSDT and without DSDT
-Nvidia Fermi Patches
-Trim Enable
-Atherors