BoomR
Moderator
- Joined
- Dec 18, 2011
- Messages
- 1,256
- Motherboard
- Gigabyte Z490 VISION D
- CPU
- i9-10850K
- Graphics
- RX 580
- Mac
- Classic Mac
- Mobile Phone
I'm doing a Cube!! (is there a 12-step program for Hackintosh builders??) I've chosen the ASRock H77M-ITX board because I want to locate the board in the same general spot that the G4 Cube's mobo was located.
The Gigabyte ITX board that most people use has the DIMM slots virtually flush with the edge of the mobo, which conflicts with the Cube's touch-sensor power switch (as does the only ASRock board where I can get a DSDT patch file from Maldon's forum). The H77M-ITX board is a little more forgiving, offering a couple mm between the edge of the board & the first DIMM slot. SO.... Since there's no DSDT file in our Tonymacx86.com database AND there's no patch file on Maldon's forum, I'm trying to "roll my own"...
Based on reading DSDT 101 over on Maldon's forum, I've applied the following patches:
Power Management:
LPC Sandy Bridge
HPET
USB:
EHCI
ICH9 USB sleep
Others from DSDT 101:
RTC
ACL892
DTGP
IRQs
SMBUS
I'm attaching a "fresh" extract of the baseline DSDT (I re-flashed the bios, then used DSDT Editor to extract after initial 10.7.3 UniBeast install), as well as the patched version that compiles with no errors (thanks to some help from Cassio over on olarila.com).
No matter what I try with MultiBeast (including the new options for patched AppleIntelCPUPowerManagement for 10.7.3 and using the iMac 12,2 system def), I still have no luck. Either freeze or KP. Joy.
I welcome any insights or suggestions. THANKS!
The Gigabyte ITX board that most people use has the DIMM slots virtually flush with the edge of the mobo, which conflicts with the Cube's touch-sensor power switch (as does the only ASRock board where I can get a DSDT patch file from Maldon's forum). The H77M-ITX board is a little more forgiving, offering a couple mm between the edge of the board & the first DIMM slot. SO.... Since there's no DSDT file in our Tonymacx86.com database AND there's no patch file on Maldon's forum, I'm trying to "roll my own"...
Based on reading DSDT 101 over on Maldon's forum, I've applied the following patches:
Power Management:
LPC Sandy Bridge
HPET
USB:
EHCI
ICH9 USB sleep
Others from DSDT 101:
RTC
ACL892
DTGP
IRQs
SMBUS
I'm attaching a "fresh" extract of the baseline DSDT (I re-flashed the bios, then used DSDT Editor to extract after initial 10.7.3 UniBeast install), as well as the patched version that compiles with no errors (thanks to some help from Cassio over on olarila.com).
No matter what I try with MultiBeast (including the new options for patched AppleIntelCPUPowerManagement for 10.7.3 and using the iMac 12,2 system def), I still have no luck. Either freeze or KP. Joy.
I welcome any insights or suggestions. THANKS!