Installation Failure (Screenshot attached)

[tom214]

You can reboot your computer now.
Using MultiBeast after upgrading to 10.6.8 always (in my case) shows "The installation has failed".

You should now be able to boot without iBoot

 

[rogerphilip]

You can reboot your computer now.
Using MultiBeast after upgrading to 10.6.8 always (in my case) shows "The installation has failed".

You should now be able to boot without iBoot

Hey Tom!

Thanks for the advice...

But now it seems to have worsened... I can't boot even with iBoot, let alone without it.

It just sits at the grey screen with white apple logo when tried to boot using iBoot.

When I tried to boot with -v command, here's what happened... (Photo attached)

Any advice is much appreciated

Thanks a lot...
-Roger

P.S. I feel I'll get there if I don't give up!

 

[tom214]

Boot gets stuck with "PCI configuration begin"
Do you have any PCI card plugged? If yes, try to boot unplugged.
Are you able to boot in safe mode? (try -x -v)

 

[rogerphilip]

Boot gets stuck with "PCI configuration begin"
Do you have any PCI card plugged? If yes, try to boot unplugged.
Are you able to boot in safe mode? (try -x -v)

No, there is no extra card...

And no, I am not able to boot with -x

With -v, I see that screen that I just showed in the last post.

What could be it?

-Roger

 

[samisnake]

try using -npci=0x2000

 

[rogerphilip]

try using -npci=0x2000

Tried that already... No luck.

Still the same grey screen without the rotating circle.... for indefinite amount of time...

 

[tebogo]

I do have the same problem. I had a working system (10.6.8) but with a unstable Ethernet. I tried to fix it with Multibeast and ended with a AppleLogo screen without spinning wheel.

I tried:
PCIRoot=1
PCIRootUID=1
npci=0x2000
GraphicsEnabler=YES|NO
"GraphicsMode"="1280x1024x32"

all with or without combinations and with or without -x -v -s -F or -f.

Any other solutions?

 

[tebogo]

Solved!

I don't no why but running Multibeast changed my .plist.
It changed legacy_kernel to mach_kernel.

With bootflags:

legacy_kernel npci=0x2000 pciroot=1​

i got my system running again.

Still have the old original problem why i started running multibeast:
My ethernet-connection is not stabele.
I have a VIA VT6102 build-in ethernetcard with de original driver from VIA

http://www.viaarena.com/Driver/v6107_vt ... 46fvia.zip

Can some one help me?

 

[kaahl]

Can you give a more detailed step by step instruction on how you changed the .plist value and where? I am having the same problem as you but am even more of a noob. How do i go about replicating your fix?

 

[kaahl]

Can you give a more detailed step by step instruction on how you changed the .plist value and where? I am having the same problem as you but am even more of a noob. How do i go about replicating your fix?