- Joined
- Dec 14, 2017
- Messages
- 16
What you apparently miss is to carefully read my guide.
I clearly state that one has to disconnect all drives except the destination drive for the windows installation when performing the Windows installation. You did not follow this important advice! Now windows has reformatted the EFI-Partition on your 10.13 System Disk.
Great
You definitely like to rub it in don't you...
Anyway. Luckily nothing of what you replied was needed, no reinstall of MacOS nor Windows, nor any reformat. Windows was installed on a separate drive but did install on the EFI of the NVMe as well unfortunately. The Clover files were still there, only the MS ones too. I was able to fix it by renaming CLOVERX64.efi into bootmgfw.efi after this Clover booted again, and I can boot MacOS as well as Windows!
BTW in your guide it states:
2.) /AI Tweaker/Internal CPU Power Management/
a.) Enhanced Intel Speed Step Technology: Disabled
and a bit further you write:
4.) /Advanced/CPU Configuration/CPU Power Management Configuration/
a.) Enhanced Intel Speed Step Technology (EIST): Enabled [fundamental for proper IPG CPU power consumption
display]
This is the same setting... Does it need to be on or off?