Z170X-UD5 TH & GTX 950 No signal after Apple logo (Sierra)

[TeK9Samurai]

I just switched out my GTX 760 to a Gigabyte GTX 950.
Hoping it would be a simple swap, I was wrong.
Everything was working fine with the GTX 760 and now I get No Signal from my monitor after the Apple logo.
Uninstalled and reinstalled the nvidia webdrivers. Also ran the AGDPfix and the following shell commands (kextcache -system-prelinked-kernel and kextcache -system-cache).
I am running an Smbios of 14,2 with clover parameters of Inject System ID and NvidiaWeb.

The only way I am able to access my Hackintosh is if I remove use Nvidia Webdrivers from Clover or nv_disable=1.
I am stumped and would appreciate the help of all you gurus.
I have been up and down this forum but cannot find anything that resolves my issue.

Thank you in advance.

 

[hafaisyy]

Have u tried to boot from clover using your USB drive?

 

[BreBo]

The only way I am able to access my Hackintosh is if I remove use Nvidia Webdrivers from Clover or nv_disable=1.

Did you setup emulated NVRAM to store the nvda_drv=1 boot flag, see Problem 6 of Solving NVIDIA Driver Install & Loading Problems

 

[TeK9Samurai]

Did you setup emulated NVRAM to store the nvda_drv=1 boot flag, see Problem 6 of Solving NVIDIA Driver Install & Loading Problems

Checked my clover, it had all those settings configured.

Have u tried to boot from clover using your USB drive?

It boots just fine without hardware acceleration. Same outcome as if I boot without webdrivers through my ssd.

 

[TeK9Samurai]

Ended up getting tired of this and purchased an AMD RX 460.
No need to play around with drivers or wait for NVIDIA.

Just need to figure out HDMI audio.