Usb 3.0 not work after mavericks

[maddizzar]

Hi, i upgrade my probook to maverick and usb 3.0 not work anymore. I patch usb 3.0 with ProBook Installer 6.1.10 but no luck. Any suggestions? thanks.

 

[asmith1234]

Have you tried Multibeast 6.0.0 and installing (under Drivers at the top and then Misc on the left) "USB 3.0 - Universal by Zenith432 ?

I had to do that to get USB 3 working on my Hackintosh/CustoMac not sure if it's the same for your Probook?! Worth a shot in any case.

Good Luck!

asmith1234

 

[grumero]

If you have a Renesas Electronics USB 3.0 Controller in your 4530s you could try to upgrade your firmware for the controller.
Download is on the HP support site here:
http://h20566.www2.hp.com/portal/si...x.portlet.endCacheTok=com.vignette.cachetoken

Maybe your USB 3.0 is working in Maverick with the new firmware.

If you also run Windows on your machine you have to update the HP USB windows drivers too otherwhise your ports will not work.

Cheers.

 

[maddizzar]

thanks, I'll check it out.

 

[nguyenmac]

thanks, I'll check it out.

You selected DSDT 3.0 patch in PBI? Did you read in RehabMan's guide that it's only for 7-series chipset?

Remove your Extra/DSDT.aml and run PBI again.