- Joined
- Aug 11, 2012
- Messages
- 21
- Motherboard
- Gigabyte Z77M-D3H-MVP
- CPU
- i7-3700K
- Graphics
- GTX 660 Ti
- Mac
- Mobile Phone
That sounds about right, although most people are getting 1000-1020, but it's nothing to cry over. You may have just found a fix for the FCPX problems, but the question is how does it perform with adobe apps? Have you tested any of those?
Ta.
Unfortunately, all I have access to is iMovie, FCPX, Compressor and Motion - no Adobe. All I have tested is FCPX and Compressor.
I added the CPU+GPU in Luxmark and got 1125, which I guess is comparable to what you're talking about.
Compressor, oddly won't start a render from Compressor itself on the Hackmac, but I don't think it's to do with the GPU. If I send a job via FCPX Export Using Compressor Settings works fine. Send the same job to Compressor from FCPX, select the same Settings and a Destination preset, and it refuses to start to Submit: "One or More targets are incomplete" error, despite all necessary info being there, the same setting preset working under FCPX, and the destination being freshly defined. Still investigating that one.
For the record, my setup was as follows:
Started on machine without GPU installed (details in signature).
Fresh install of MLion 10.8.1 via UniBeast
Multibeast: UserDST, Trim Enabler, NVDIA GTX 670 (whoops - error on prev. post - looks like I installed it after all), Maolj Atheros Ethernet, Chimera, MacPro 3.1, TonyMac theme. Reboot.
Lacie USB3.0 Drivers. Reboot.
Trim Enabler (separate programme - http://www.groths.org/?page_id=322 - Multibeast Trim Enable didn't stick for me)
Graphics Mode = 1920x1200x32 (manual insert into org.chameleon.boot.plist for my Apple Cinema display)
Used the machine on internal graphics for a couple of days.
GraphicsEnabler = No (manual insert into org.chameleon.boot.plist - still booted with internal graphics, just very slow and screen settings all messed up)
Installed 660Ti (all working, 2 DVI monitors, had that slow boot I mentioned earlier)
BIOS Internal Graphics = Auto (fixed the slow boot)
... and that's where I'm at - satisfactory working and stable. Word on other forums is that there's a fix in MLion 10.8.2 soon, so waiting on that, fingers crossed.