- Joined
- Nov 2, 2010
- Messages
- 61
- Motherboard
- Ignore me
- CPU
- I'm Ignoring
- Graphics
- the Forum RULES !!!!
This is my third build - I started back on Snow-Leopard, had a Mavericks build and now with the new hardware I obviously can not figure out to get this High-Sierra-Installer running from USB with success.
BTW: If there is a buyers-guide with recommended hardware-selection fx. from the category "CustoMacPro" - why is there no step-by-step-guide matching a given build and OSX-version then?
What I have done so far, which hopefully kind of points in the right direction (based on 5-10 different threads):
- Changed BIOS to recommended settings
>>
BIOS TAB
BIOS Features > Windows 8/10 Features > Other OS
BIOS Features > Storage Boot Option Control > UEFI Only
BIOS Features > Boot Option #1 > UEFI USB Drive
Peripherals TAB
Initial Display Output > PCIe 1 Slot
Peripherals > XHCI Hand-off > Enable
Network Stack > Disabled
Chipset TAB
VTd > Disabled
Internal Graphics > Disabled
- Made a high-sierra-usb-install-stick
- Installed Clover 4243
-- In clover selected:
-- Install for UEFI booting only
-- Install Clover in the ESP
-- Drivers64UEFI
-- Tried with/without EmuVariableUefi-64 (no succes)
-- Tried with OsxAptioFixDrv-64 or OsxAptioFix2Drv-64 (no success)
Edited the following in config.plist
FakeCPUID ->> 0x0506e3
CsrActiveConfig ->> 0x67
Researched a ton of potential relevant forum-postings - tried a lot other desperate things...
Any hints appreciated.
BTW: If there is a buyers-guide with recommended hardware-selection fx. from the category "CustoMacPro" - why is there no step-by-step-guide matching a given build and OSX-version then?
What I have done so far, which hopefully kind of points in the right direction (based on 5-10 different threads):
- Changed BIOS to recommended settings
>>
BIOS TAB
BIOS Features > Windows 8/10 Features > Other OS
BIOS Features > Storage Boot Option Control > UEFI Only
BIOS Features > Boot Option #1 > UEFI USB Drive
Peripherals TAB
Initial Display Output > PCIe 1 Slot
Peripherals > XHCI Hand-off > Enable
Network Stack > Disabled
Chipset TAB
VTd > Disabled
Internal Graphics > Disabled
- Made a high-sierra-usb-install-stick
- Installed Clover 4243
-- In clover selected:
-- Install for UEFI booting only
-- Install Clover in the ESP
-- Drivers64UEFI
-- Tried with/without EmuVariableUefi-64 (no succes)
-- Tried with OsxAptioFixDrv-64 or OsxAptioFix2Drv-64 (no success)
Edited the following in config.plist
FakeCPUID ->> 0x0506e3
CsrActiveConfig ->> 0x67
Researched a ton of potential relevant forum-postings - tried a lot other desperate things...
Any hints appreciated.
Last edited: