[SOLVED]Need Help! Hangs at gray Apple screen with DSDT

[shinew]

I've been running SL w/o an issue for some time, my build is in my signature. So after I've finally decided to upgrade to Lion, everything runs pretty much perfect after installation when I booted using USB. However, I just cannot figure how to make it work using DSDT. It always hangs at hte gray apple logo screen with no spinning wheel. When I tried with the -v flag, it hangs at [PCI Configuration Begin], but I do not see any kernel panic.

I upgraded(also tried fresh install with the same result) using the unibeast + USB method, and downloaded multibeast 4.2.1. Below is the list of things I've installed:

I've searched quite a bit, many seem to have similar issue but none with the solution. tried npci=0x2000, PCIRootUID=1 with the same result. Currently I'm tempted to just boot with USB everytime... Please share if you have any idea of what's going on, thanks!!

 

[rene204]

Re: Need Help! Hangs at gray Apple screen with DSDT(P55-USB3)

try out to boot with kernelflag:

npci=0x2000

here ist is working for me..

 

[shinew]

Re: Need Help! Hangs at gray Apple screen with DSDT(P55-USB3)

try out to boot with kernelflag:

npci=0x2000

here ist is working for me..

done that, same result. it was a typo, i meant "npci=0x2000" in my post.

 

[freakyuno]

Re: Need Help! Hangs at gray Apple screen with DSDT(P55-USB3)

Also try to boot with

GraphicsEnabler=no or -x and see if that gets past the pci configuration error.

 

[shinew]

Re: Need Help! Hangs at gray Apple screen with DSDT(P55-USB3)

Also try to boot with

GraphicsEnabler=no or -x and see if that gets past the pci configuration error.

same thing...

 

[shinew]

SOLVED! This post nailed it dead on: http://www.insanelymac.com/forum/index. ... &p=1768536

going to update to 10.7.3 and see if there're any issues.