Problem with installing el capitan on Asrock H170 PRO4 and i5 6500

[ssdgfs]

Hi,
I have problem installing el capitan on Asrock H170 PRO4 and i5 6500

I have read similar posts like this but i can't solve this.
If i try installtion without safe mode i get stuck on black screen with apple logo and progress bar

I attach prints from safe and verbose mode

Version of el capitan is 1.7.46

In bios i have :
VT-d: disable
Secure Boot Mode: disable
IO SerialPort: disable
sata mode selection: AHCI
Also setup primary graphics adapter to onboard (from pci express. tried and with pci express)


I have tried
-v nv_disable=1
-v dart=0 nv_disable=1 kext-dev-mod=1 -x -x cpus=1 and much other with no result

Thanks in advance

Regards,
S

 

[audiojunk66]

Try to set USB Ownership to yes(true) in CLover that did it for me with my Z170M Pro4S.

http://www.tonymacx86.com/threads/how-can-i-boot-without-usb-on-asrock-z170m-pro4s.193790/

 

[ssdgfs]

Try to set USB Ownership to yes(true) in CLover that did it for me with my Z170M Pro4S.

http://www.tonymacx86.com/threads/how-can-i-boot-without-usb-on-asrock-z170m-pro4s.193790/

Thank you so much! You save my day!!!
This work like a charm!

Thanks again!

Regards,
S

 

[ssdgfs]

Hi,
after successful installation, i run multibeast with the same settings as here
Also check again the ownership fix in config.plist

But when try to login the system crash (black screen without logo and without progress bar) about 60% - 70% of progress bar.
System also crash in safe and verbose mode.

When i boot from usb i can login without any problem into El Capitan installed on hard disk, so i suppose that the problem in hard disk's efi config.plist

The differences are only in kernel and kext patches and in SMBIOS

Any suggestion?

Regards,
S

 

[ssdgfs]

If I replace the config.plist with this from usb i can boot normal but, i think without all drivers. Could i try an other config?