- Joined
- Oct 21, 2011
- Messages
- 10
- Motherboard
- Gigabyte Z77X-UP5TH
- CPU
- i7 3770K
- Graphics
- GTX 670
Hi everyone! I'm a complete newbie building my first Hackintosh and I'm running into some problems. I followed the Tonymac Unibeast Installation guide for Mountain Lion to a T and I can install off the USB drive just fine, it boots in OSX for the first time and I download and run Multibeast and I select everything exactly as the screenshot says for a DSDT-Free installation (system info below). When I rebooted after running Multibeast I was getting the Boot0 error so I did the Terminal fix and that seemed to work. However, when I boot up, it will come to the Tonymac startup screen then show the grey Apple screen with the spinning line-circle (in less than full screen), then the screen goes black for a second then comes to a grey screen and goes no further. No mouse pointer or anything on the screen, just a blank light grey screen.
Any suggestions? I've searched extensively on the forums but can't seem to find an answer.
Here is my system info (I based it off the Tonymac CustoMac suggestion):
- Gigabyte Z77X-UP5 TH
- Intel i7-3770K LGA1155
- Gigabyte GTX 670
- Corsair 32GB RAM
- 1 TB Seagate Barracuda SATA 6 Gb/s
The only thing different hardware wise from the suggested build is that I have an LG Blu-Ray burner also installed, however, it's supposed to work fine with OSX.
I've tried using only the onboard graphics vice the 670, but that doesn't seem to help.
Also, this is probably a stupid question, but is there a way to edit your Multibeast or system tweak without having to re-install every time?
Thank you so much for your time and help!!! Anything you can suggest would be greatly appreciated!
Any suggestions? I've searched extensively on the forums but can't seem to find an answer.
Here is my system info (I based it off the Tonymac CustoMac suggestion):
- Gigabyte Z77X-UP5 TH
- Intel i7-3770K LGA1155
- Gigabyte GTX 670
- Corsair 32GB RAM
- 1 TB Seagate Barracuda SATA 6 Gb/s
The only thing different hardware wise from the suggested build is that I have an LG Blu-Ray burner also installed, however, it's supposed to work fine with OSX.
I've tried using only the onboard graphics vice the 670, but that doesn't seem to help.
Also, this is probably a stupid question, but is there a way to edit your Multibeast or system tweak without having to re-install every time?
Thank you so much for your time and help!!! Anything you can suggest would be greatly appreciated!