neilhart
Moderator
- Joined
- May 25, 2010
- Messages
- 2,686
- Motherboard
- ASRock Fatal1ty Z270 Gaming - ITX/ac
- CPU
- i7-7700T
- Graphics
- GTX960
- Mac
- Mobile Phone
neilhart's Prodigy "The White One" work log started.
As you can see, I have the right side panel modified to clear the PCI Slot panel. I have gone ahead and produced an approximately 12 inch 24 pin power cable and connected up all of the harness in a temporary set up to test out the new power supply (it is a SilverStone 500 w Stridder Plus - fully modular unit). This was the first power on for the new PSU and first power on for the system in the new case. I will run it now overnight just to get some confidence in the system...
and
I pulled the front panel as it seems to restrict air flow as I had suspected. I have a 200mm fan in the front and no rear and no top fan for now
more soon.
neil
As you can see, I have the right side panel modified to clear the PCI Slot panel. I have gone ahead and produced an approximately 12 inch 24 pin power cable and connected up all of the harness in a temporary set up to test out the new power supply (it is a SilverStone 500 w Stridder Plus - fully modular unit). This was the first power on for the new PSU and first power on for the system in the new case. I will run it now overnight just to get some confidence in the system...
and
I pulled the front panel as it seems to restrict air flow as I had suspected. I have a 200mm fan in the front and no rear and no top fan for now
more soon.
neil