Moarfish's build - GA-B75M-D3H i5 3570K

[moarfish]

Hi Moarfish, I have almost the same Build but can only boot in Safe Mode, can you help me?

OS: ML 10.8.3
Mobo: B75M-D3H
CPU: i5 3570k
RAM: 1x8gb Adata 1333mhz
HDD: Seagate Barracuda 500gb
Optical Drive: LG DVD
Wifi Card: TP-LINK TL-WDN4800

I already double and triple checked all the steps and this is what i get in verbose mode

Thanks

It looks like everything should work fine with the config you said above.
Are you using HD4000 as display or you got a Display card instead?
From which step you start facing cannot boot problem?

 

[spranks]

It looks like everything should work fine with the config you said above.
Are you using HD4000 as display or you got a Display card instead?
From which step you start facing cannot boot problem?

I'm using the HD4000 with HDMI. I can install OSX with no problem but when I try to boot afterwards I have to do it in Safe Mode even after I installed Multibeast

 

[moarfish]

I'm using the HD4000 with HDMI. I can install OSX with no problem but when I try to boot afterwards I have to do it in Safe Mode even after I installed Multibeast

So you start facing problem on this step?
6. Boot the new Mountain Lion Volume from the USB

If yes, I think it may be the problem of BIOS settings.
Make sure you set the Internal graphic memory to the default settings.
You may try turn off VT as someone suggest but for me I just have to use the default BIOS settings and just switch SATA to AHCI.

I think you can try reset the BIOS settings to the factory default and just turn the SATA to AHCI and try again.

 

[spranks]

So you start facing problem on this step?
6. Boot the new Mountain Lion Volume from the USB

If yes, I think it may be the problem of BIOS settings.
Make sure you set the Internal graphic memory to the default settings.
You may try turn off VT as someone suggest but for me I just have to use the default BIOS settings and just switch SATA to AHCI.

I think you can try reset the BIOS settings to the factory default and just turn the SATA to AHCI and try again.

just tried that and and still doesn't work

 

[moarfish]

Updated to 10.8.4

as Simple as before.

1. Permission Repair, Install the Combo Updater, do not reboot.
2. Open Multibeast 5.3.1, reinstall the Sound driver.
3. Reboot. Permission Repair again.

 

[Modit]

Hi Moarfish need some help here after i started using Muiltibeat 5.3.0 when i shutdown the computer it does not fully shut off the pc just hear it powers down the hard drive and never turns the computer off just started having the problem since 5.3.0 did a fresh install today updated to 10.8.4 and used the Multibeast 5.3.1 and same problem. Know why am hiving the problem?

 

[Stork]

In the BIOS, turn off Wake-On-LAN. See thelostswede's article Quick guide to configuring the UEFI on Gigabyte's 7-series LGA-1155 motherboards

 

[Modit]

There is no settings for wake on lan in the bios for this board. Am using the same board GA-B75M-D3H.

 

[Adrian B]

There should be wake on Lan settings : http://www.tonymacx86.com/attachments/26491d1343913432-uefi_hpet.jpg.html

Adrian B

 

[Modit]

Yes i know what it is and where it is its just not there in this model of the board.