install lion using unibeast system can't found hdd

[paipai]

I start install lion using unibeast. when it ask to which hard drive to install lion there is no any harddrive found.

i go to disk utility it found only usb drive (uni beast drive)

what can i do please heap me T^T

*** I use SSD OCZ Vertex4 128GB***

 

[toomanyboxes]

Hi paipai

I had the same thing recently , not sure what it was , I changed the sata cables and I think I eventually could see my HDD ( but I had pulled the SSD out ) then installed there. All went well , swap the cable over and what do you know, I could see the SSD!


I have a Z68MX UD2H and I used the single blue sata connection, not the ones on the side.

I'm sure this is more about which connection for which board rather than a unibeast problem and I am sure I read somewhere that they had the same problem

Cheers

 

[tschulz]

I am having the same issue.

Specs:
GA-Z68XP-UD3
Crucial 256 GB SSD
Samsung 2T HDD

When I press F12 to boot to the UniBeast, I motherboard recognizes both of the hard drives. However, when I am in the Mac OS X Installer, there are no disks found.

I tried removing all but 4 GB of Ram, no change
I tried all 6 Sata ports for the hard drives, no change
I tried the PCIBoot commands, no change
I installed OS X on a USB Flash Drive but was unable to boot to it after it was installed.
I installed OS X on a FireWire HardDrive but was unable to boot to it after it was installed.

Any other ideas?