- Joined
- Sep 19, 2013
- Messages
- 34
- Motherboard
- Asus p8 z77
- CPU
- i7 2600k
- Graphics
- GTX 650 Ti
- Mac
- Classic Mac
- Mobile Phone
Hi mate,
I've been the following the guide and I have clover and Mavericks installer on the USB. When I select to boot the Mavericks installer the verbose text starts running through as normal, then the system stops sending video signals and the monitor shows "no signal" as it would of the System was turned off or the cable was unplugged.
At this time the USB device's light stays solid as it does when it's functioning but not being accessed, as opposed to rapidly pulsing when it's trying to boot something.
I've tried both the minimal config.plist and the nVidia config.plist attached in the topic and I have tried booting with GraphicsEnabler=No
It's the same thing every time.
If I try to boot to Mavericks from clover on the USB, it shows error:
and then it restarts
I can still boot to mavericks if I boot using Chameleon which is also on the USB device.
Regards
-J
I've been the following the guide and I have clover and Mavericks installer on the USB. When I select to boot the Mavericks installer the verbose text starts running through as normal, then the system stops sending video signals and the monitor shows "no signal" as it would of the System was turned off or the cable was unplugged.
At this time the USB device's light stays solid as it does when it's functioning but not being accessed, as opposed to rapidly pulsing when it's trying to boot something.
I've tried both the minimal config.plist and the nVidia config.plist attached in the topic and I have tried booting with GraphicsEnabler=No
It's the same thing every time.
If I try to boot to Mavericks from clover on the USB, it shows error:
Code:
P-State Stepper Error 18 at step 2 in context 2 on CPU 0
I can still boot to mavericks if I boot using Chameleon which is also on the USB device.
Regards
-J